Teg thermal paste

First thanks for the invite.
I'm just wondering what the best thermal paste to use.
Also where might I get ahold of some catalyst beads.

What machine do you have?

The Independence reportedly runs the TEG at about 200°C on the hot side, and a few high temperature modules are spec'd to 230°C (pretty close to 200°). This discussion of TEG modules may be helpful.

You might take a look at this site, which advertises "Thermal Interface Materials," which include graphite sheets a.k.a. "Graphite Thermal Interface Foil." According to them, "Graphite foil TIM is the only TIM able to survive temperatures above 250°C (482°F), so it is an essential choice for use on Thermoelectric Generators TEGs." Good Luck!

Thanks for the info
I'll check it out